Using a dye sublimation printer for sublimation transfer has changed the ink supply, it is easy to block the nozzle, it is difficult to maintain, and the stability is not enough.How to effectively save costs has become an important issue in the current office field. With the increase of daily printing volume, the proportion of consumables is getting bigger and bigger, even surpassing the printer itself. In the case of limited funds, printing will undoubtedly become a huge burden. At the same time, as printers enter the home, many home users are also beginning to face this problem.
Buying inkjet sublimation printers at a lower price is often left idle at home because of thermal transfer inks, continuous ink supply systems, also known as printer gas stations, system modifications. Do not damage the printer, do not have to replace the ink cartridges during printing (for Epson models), and avoid soiling your hands when filling ink. The particles in the ink are too large. In the past, the printer inkjet was a minimum of 3 microliters. Now the r270 is 1.5 microliters. The corresponding nozzle is also much smaller, so it is easy to cause plugging.
How to avoid and solve sublimation transfer printer plug problems?
Use the following method to avoid sublimation printing machine nozzle plugging. First, go to the medicine store and buy a syringe with a diameter of 30 mm and a filter with a pore size of 1 μm (preferably one color). After buying it, pump the ink to the syringe and install it. Ultrafilter and needle, the ink is slowly injected with the needle facing down. (Note: Air cannot pass through the ultrafilter, there must be liquid inside). Principle: After using 1 micron ultrafiltration, most bacteria can be filtered. (Ultrafilter is also called sterile filter) The rest of the principle is not to say it! Of course, this is the solution. It is also very important to choose high-quality thermal transfer ink. The quality of the thermal transfer inks on the market is very messy and the price is very chaotic. Many friends buy low-cost thermal transfer in order to save money. Ink, the more granular the cheaper ink, the easier it is to block the printer nozzle, so try to use a sublimation ink with a small amount of good quality particles.