Instructions
a) Lift the handle so that the machine is open.Put the target products on the working platform,
testing pressure if is appropriate, and not, need to adjust the pressure knob. (Turn the knob
clockwise to increase the pressure, counter-clockwise to decrease pressure);
b) Open the machine, ready to hot stamping products. (Heating process, please do not be stamping
is placed on the working platform, in order to avoid bad roast)
c) Turn the power switch on , temperature controller starting self-test, self-test for about 10 seconds to complete and enter the working state, then setting the working
parameters (for the first time, set up the required:the temperature, time, see attached time and
temperature instrument panel operating instructions)
After setting the temperature well, the time, the machine starts to heat up heating (the temperature rose to 200C degree takes about 15 minutes)
d) When the machine until desired temperature is reached, will require the transfer of goods tile
placed on a table, hand pressed, the machine starts automatic timing, after reaching the set time,
the machine issued a warning tone, lift the handle to complete the last operation.
Note: For security reasons, the power supply must meet a protective ground wire single-phase
three-wire power supply.
Note
1.If it is cool sublimation paper, printing completed. please waiting 15-20 seconds. Then tear it off. If it is heat
sublimation paper, printing completed, please tear off the paper asap (Diagonal grain to tear down the clothes).
Successful printed, need right time, temperature and pressure;
2.The final printed result depend on the products thickness,material and variety of sublimation paper.
3.Different kinds of printing, please testing the sample. After get right time and temperature, then volume
production.